• Movable beam with 4-point mechanical self-lubricated guiding system
• Double protection against unwanted or excessive tilting
• Interchangeable bolt-on wide bed
• Full electronic-hydraulic synchronism of the ram (axes Y1+Y2)
• Electronic stopping of the ram within ± 0.0004" max deviation
• Bending depth adjustable under load by the DNC control
• Deep gap in frame for bending long flanges over full length of machine
• Full programming of the bending angle (with 0.1 degrees resolution)
• Programming of the bending speed and return speed (10 to 100%)
• Tonnage programming based on programmed tool library
• Hydraulic cylinders honed and hard chromed for maximum durability
• Low-noise pump
• Inch set-up, semi-automatic, and automatic modes of operation
• One set of adjustable punch holders which hold both American and European style forming punches.
          These punch holders allow the operator to crown the upper punch to
          compensate for deflection or tooling wear, and provide greater flexibility
          when forming boxes and panels.
• Electric foot switch on a trailing lead
• DNC 62 Control for Y1/Y2 standard
  (optional ModEva 2D or 3D color graphics control)

Machines can be equipped with a wide range of
optional tooling, axes, and controls:
X, X-X1, X1-X2, R, R1-R2, Z-Z1, Z1-Z2,
crowning, front support arms, bending followers, and more!