COMEQ - IMAC Notchers

The variable angle notching machines are equipped with: - Oleo dynamic working through two cylinders. - An absolute rigidity of the notching group is provided by lateral columns and by a central guide. - A large and rigid working table with directional triple functions engraved brass scales for measuring the various types of notches. - Squaring guides equipped with reference holes every 15°. - A head configuration allowing cuts longer than the blade length. - Blade holder sector blocking through eight cylinders and a safety device preventing the machine from any movement when the blades are released. - Six slots with brass scales on the working table to enable the operator to use disappearing references and to obtain complex notching.
- Electronic stroke regulator with digital reading. - Brass measuring scales with a triple function guarantee a quick set up of the piece and a long endurance. - A cutting zone protection sheet in Polycarbonate that gives you uninhibited sight of the working area while assuring your maximum safety. - Fixed adjustment of the upper and lower blades with rectified guides in order to guarantee parallel movements among the blades. - Reversible blades in HSS (high-speed steal) that enable the operator to choose both a positive cutting direction (that is a cutting from the front side) and a negative cutting direction; that is cutting from the back side. These blades are available at 30° and 60° and are optional. - A control board from which it's possible to select the single stroke working or shot working in order to make it easy to personalize and optimize the time thanks also to the electronic stroke regulator which sets a limit to the stroke to a pre-arranged position according to the requirements. - Internal stroke to turn the notching machine into a small shearing machine in order to get straps with a maximum length of 200 mm. - Swarf collecting box.