COMEQ, Inc. [TITAN Rolls]

This is a modern, initial-pinch type machine capable of rolling full or partial cylinders. The machine is simple to operate yet produces high quality rolling results very efficiently. The three rolls are journalled in anti-friction roller bearings. The upper and lower rolls are driven by a worm gear motor with built-in braking, providing a single rolling speed. Variable rolling speeds are optional. The upper roll is securely locked in place at the outboard end while rolling. To remove finished cylinders, the top roll is easily released and automatically balanced as it is swung to the side. Both the lower roll and the rear bending roll are easily adjusted by handwheels through worm gears.* The handwheels, located at the end of the machine frame, raise and lower both ends of the roll together, maintaining true roll position and eliminating the need to adjust both ends of the roll individually. With the standard equipment, the machine is ready to run and fill almost every requirement.

Capacities and Specifications

Machine
Size

Operating
Length

Capacity
Mild Steel

Diameter
of Rolls

Rolling Speed
Feet/Min.

Motor
HP

Weight
Lbs.

IP 60/2

25"

14 ga.

2.36"

3/4

350

IP 60/3

40"

16 ga.

2.36"

3/4

470

IP 80/3

40"

13 ga.

3.15"

870

IP 100/3

40"

10 ga.

3.93"

1�

1460

IP 110/3

40"

3/16"

4.33"

1�

1540

IP 140/3

36"

1/4"

5.51"

2200

IP 60/4

50"

18 ga.

2.36"

3/4

530

IP 80/4

50"

14 ga.

3.15"

960

IP 90/4

50"

12 ga.

3.54"

1100

IP 110/4

50"

7 ga.

4.33"

1�

1680

IP 140/4

48"

1/4"

5.51"

2500

IP 80/5

60"

16 ga.

3.15"

920

IP 90/5

60"

14 ga.

3.54"

1160

IP 110/5

60"

10 ga.

4.33"

1�

1810

IP 130/5

60"

3/16"

5.12"

2480

IP 90/6

80"

16 ga.

3.54"

1370

IP 100/6

80"

14 ga.

3.93"

1�

2100

IP 120/6

72"

10 ga.

4.72"

1�

2150

IP 140/6

72"

3/16"

5.51"

3100

IP 110/8

96"

16 ga.

4.33"

1�

2300

IP 120/8

96"

14 ga.

4.72"

1�

2500

IP 140/8

96"

1/8"

5.51"

3700

Standard Equipment

Rolls journalled in anti-friction roller bearings *
Swing-out upper roll (drop end)
Brake motor and controls for 3/60/220/440
Portable push button controls for Forward/Reverse, on a trailing lead
Low voltage at the controls
Safety cable at front and rear of machine
Indicator scale for the position of the bending roll
Longitudinal groove in the rear roll

Optional Equipment

Cone bending attachment, including tiltable rear roll with built-in dial indicator *
Motor powered bending roll adjustment *
Motor powered lower (clamping) roll adjustment *
Push button controls mounted in a swing-arm *
Variable rolling speeds *
Hardened and ground or rubber covered rolls
CNC Controls